Hi mate. All the bits came from a guy called Bernie over in Perth. All up cost me $850 but if your king pins are ok will only be about $700. That's for flipped spindles and a straight axle kit. You also need to source a straight axle tranny, but has to have long axles. Apparently there is a long and a short. As far as fitting goes, it is a piece of cake. Honestly mate you could do it in a day if you had all your bits ready to go. I replaced my link pins at the same time. Handbrake cables, bearings etc so allow another couple of hundred bucks I guess. I can give you Bernie's details if you decide to go with it. I hope to be back on the road by the end of this week end. I will let you know when I'm done and might come for a run up your way and you can take a look at it. I'm super happy with the result so far. Chat soon.