Thanks Mark. Will go and view hopefully this week and fingers crossed it’s there
Thanks man you have been very helpful. Fingers crossed I can find one
Anyone have a photo of what the compliance plate looks like by chance?
thanks mate will see what is behind the passenger seat
If possible can you tell by looking at the poptop? if so its at milesonmillie.com.
to be honest mate i dont know. it s a straight up and down poptop if that helps.
If it did have a compliance plate on it where would that be located?
needing some advise pretty urgently.
Have moved from Aussie back to NZ and brought our 1975 Bus with us. For compliance they are needing...
Cool it must be to the top but I have that had a cap on it. Will see if I can get the pieces and make it work. Cheers team
soinds silly for me to say this but when cold and the gap is bigger is that letting fuel in? Could that be the case of the fuel smell?
I do have a point on top of the air filter case which has a cap on it that can be removed. Might see what the mechanic says tomorrow. I can’t seem to...
I think it may be the throttle arm? Is it suppose to be hard against the base play or a gap between the 2?
On the below photo where the arrow is pointing. There is a gap there on both carnies. When engine is turned off should there be a gap?
Thanks mate. Looking through the manual so hopefully I can find out where it goes haha
Mate looked everywhere and can’t see where it goes to. Are you able to have a look and advise?
Separate names with a comma.