Looking for recommendation of a good quality panel beater on the Sunshine Coast.
thx Col. Nut still attached to motor. Will wait until I get home before fixing.
My window wiper motor sounds like it is working, both speeds, but it s not activating the wipers. It looks as if the wiper mechanisms are still...
Thanks Barry. Little confused on the static timing as John Muirs manual states static timing should be set a 0 degrees TDC not 7.5.
Just realised I set my valve clearances to the notch. Will the difference between tdc and timing mark be critical?
Hoping for clarification with static timing. 1970 type 2 1600, crankshaft pulley has 1 notch cut into the front that I presume to be TDC mark,...
New trick Alpal
Thx Mike and Stevie,
Checked the rubber elbows on the balance pipe and they're good. Bus seems to idle fine when up to temp. Stevie, can you give me...
Correct, twin carb type 4 with 009.
Having an issue with stalling when changing back down through the gears. Seems to idle fine when stationary. Engine not running hot and...
Looking for a quality panel beater on the Sunshine Coast, preferably Caloundra end, to complete minor rust repairs. Any recommendations would be...
Thanks Lorraine. Can't wait.
Room for one more?
Brooke & Span
Bought a Saturn travellers mate. Made in rainbow beach qld. Has a small mounting bracket that I fixed to the pop top that I slot the aerial into.
My 77 bay had the same issue which was caused by a sticky solenoid. When it stuck I had to crawl under the bus and breach the contacts on the...
Looking for a little advice regarding starter motors. Solenoid continually sticking and I'm sick of climbing under the bus to give it some...
Hi Tim & Sasa,
I recently purchased a 77' camper and its layout would sleeps 2 adults and a child.
Backseat converts into a bed for 2 and once the...
Separate names with a comma.