I finally wrapped up the engine harness. I have mounted the relays Inertia swith battery isolater switch & ECU onto a plastic bread board this will...
started the long job of the wiring harness today laid out the seperate sections turned the glove box lid upside down for ease of access to relays...
Ihope everyone has a good 2020 stay well stay safe if your in the fire zones. Our thoughts are with you all.
Looks like you used Merbau decking same as my set up
Tidy looking setup. Any pics of the mainfold arrangment
This is the way ahead in wiring. I buy of wish complete light bar driving light harness. ready to go
the main fuse box with blinker & acc...
Good morning all. been on the wiring again this time i have set up a drop down panel for the headlight high low beam relays handbrake relay the...
Thanks Steve.I has taken me longer than i like. Turning 70 in Sept slowed me down. Loosing 6 months due to shoulder rebuild. I have got a new breath...
Not to worried about it I plan on running a shield under the floor similar to the factory one I hope this will protect it a bit but point taken
Aaron Green's highly customised bay took out top ten peoples choice best of show best paint best interior.
I had to trim the mounting lug off the back of the diff housing to get enough room for the rack & pinion
this is the lug with about 4cms cut out....
fabricated the front X member for the front diff. next is to do the rear mount for it. The X member has to be moved rearward by 5cms
Hi Ryan. Once your set up you can sell if there's anyone there to buy
Good afternoon all. I had this bent up in case the new mount is still in the way. I will mount it to a bespoke crossmember with 4 Hi Ace gearbox...
Thanks David H. It's coming together now
i have to use ab aftermarket rear mount on the front diff to get room for the rack & pinion.
Good evening all. mounted the linear actuator for the handbrake today.
today was another good productive 1.
Bolted in the steering column support bar & column
this is in the up position
Fitted up the left side arm & hub brake assembly today all new nuts & bolts. I'm happy with the lift for the time being. It's stock location on the...
fitting the L300 steering column. i gad to fabricate a support beam to hold the column due to the dash panel being flimsy. the fixed VW column is ok...
Separate names with a comma.