Have you tried replacing the ignition switch. Very cheap and easy if it is a late model.
Get in touch with Andrew. 1500king on the forum.
Very common problem. They usually don't cause any damage and just get spat out the exhaust. Getting a new jet will be the biggest problem. It looks...
You should never have to fill the pressure bottle up.
Spot the tradesmen here.
I think Andrew is talking about the large post on the starter motor. There is a battery cable and a 6mm cable on the post.
I feel inadequate.
Retired Kombi drivers.
You are correct for a T2 (type 21) but this is a T3 (type 25) thread.
Rear axle nuts are much tighter on a T3 also. Real men drive T3s. They have...
Never take your vehicle back to that place. They are obviously incompetent. Proper mechanics use tension wrenches and tighten them to 180Nm...
Pre '68. After that they were imported or CKD. I have never seen the VWA logo on anything CKD although some of the parts were made in Australia until...
It's a good place to pick up some spare parts.
That sounds OK.
David meant go back and take the covers off and then take photos. I'm sure the owner wont mind.
Dave is in Nowra. (Bomaderry)
That combination would be a tight fit. You need to check offsets and track width also.
Is it a VW specialist that knows T3s that looked at it?
Diff problem could be expensive but the rest is cheap.
Get a second opinion from a...
It's if you buy a Traxide headlight relay kit.
No, intermittent is in a relay. Most modern wipers can be made intermittent by fitting the appropriate relay.
From the workshop manual. "Run engine at 3000rpm, voltage should be 13.5-14.5 volts. All components off".
Separate names with a comma.