1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

1600 Engine Support Bar

Discussion in 'Engine & Transmission' started by kool_kombi 79, Jan 28, 2018.

  1. kool_kombi 79

    kool_kombi 79 Active Member

    Messages:
    316
    Location:
    Brisbane
    I am looking into making a 1600 engine support bar and need a few things cleared up for design purposes.

    Does the rubber mounts go on the top side or inside the cavity?

    Does the long side of the steel bushes in the centre go toward the engine?

    Is the lower bolt a 8mm and the top two are 10mm bolts?

    This will help the way I can make and manufacture these components.

    Thanks
    Dale Malcolm
    Malcolm Engineering

    IMG_0247 mod.JPG IMG_0246 15%.JPG
     
  2. Old Dubber

    Old Dubber Active Member

    Messages:
    267
    Location:
    Everton Hills, Brisbane
    Inside

    Yes

    Yes
     
  3. kool_kombi 79

    kool_kombi 79 Active Member

    Messages:
    316
    Location:
    Brisbane
    Thanks
    Much appreciated
     

Share This Page