1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

75 Sopru Painting underbody

Discussion in 'Resto Corner' started by airhead3837, May 27, 2015.

  1. airhead3837

    airhead3837 Member

    Messages:
    70
    Location:
    Gymea
    As with the engine bay, I did this back in 2013. I used KBS (similar to POR15) & would recommend it, 2 years later & it still looks good. 1a; 19-08-2012.jpg 2a; 13-09-2012.jpg 3a; 13-09-2012.jpg 15a; 18-12-2012.jpg 13; 17-12-2012.JPG 16; 18-12-2012.JPG 23a; 03-01-2013.jpg 29a; 11-01-2013.jpg 28a; 11-01-2013.jpg 27a; 11-01-2013.jpg
     
    tinymcmassive and Squidy like this.
  2. KahunaKombi

    KahunaKombi Super Moderator Staff Member

    Messages:
    18,500
    Location:
    Bracken Ridge, Qld
    Nothing like a clean undercarriage ;)
     
    airhead3837 likes this.
  3. mr happy

    mr happy Active Member

    Messages:
    138
    Location:
    Brisbane
    Bit of a bump on this one but can i ask how you applied the coating airhead? Looks like a good finish,
    Mr h
     
  4. oldman

    oldman Super Moderator Staff Member

    Messages:
    7,994
    Location:
    Avalon Beach NSW
    Hasn’t been here since September 2017.......
    Might be waiting for a while.
    Maybe post a new thread in the Help and Assistance section?
    Cheers,
    Mark
     
    mr happy likes this.
  5. cbus

    cbus Well-Known Member

    Messages:
    10,841
    Location:
    sunshine coast
    Have seen this product come up very much like a sprayed finish when applied by brush. Self levels quite well.
    Prep as always is the important factor to adhesion and finish.
    As mentioned in instructions, it doesn't stick well to shiny paint surfaces.
     
    mr happy likes this.

Share This Page