1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Going back to points

Discussion in 'Fuel System & Electrics' started by REB, Feb 15, 2014.

  1. REB

    REB Active Member

    Messages:
    360
    Location:
    sydney
    HI,have had a problem with my motor since a positive lead fell off my coil.
    Now it runs alright and then will stall at lights and run rough driving along.
    If I give it more accelerator it goes alright.
    checked the coil echlinn gx80 with 3.0 ohms and 11000 ohms
    Now looking at changing compufire electronic points back to normal points,what will I need to do beside points and timing
    Have 005 vacumn distributor
     
    Last edited: Feb 15, 2014
  2. saabman

    saabman Well-Known Member

    Messages:
    4,888
    Location:
    Goulburn
    add a condensor ( capacitor)
     
  3. REB

    REB Active Member

    Messages:
    360
    Location:
    sydney
    Do I need to change the coil back to one with less ohms
     
  4. saabman

    saabman Well-Known Member

    Messages:
    4,888
    Location:
    Goulburn
    3 ohms is fine for points.
     

Share This Page