1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

I need a measurement please

Discussion in 'Off Topic' started by roverbay, Feb 16, 2015.

  1. roverbay

    roverbay Active Member

    Messages:
    864
    Location:
    nambour
    Good evening all. If anyone has a bay on stands I need the measurement with the front suspension on full drop from the centre of the guard to the centre of the spindle or the grease cap please. So I can gauge the lift before I weld the beam locator's in the centre of the tubes. I was going to use adjusters but due to the front wheel drive now hanging on them figure it may be better welded. thanks
    ernie
     
  2. saabman

    saabman Well-Known Member

    Messages:
    4,888
    Location:
    Goulburn
    Howd you go with this Ernie?

    I dont have one on stands but can easy enough arrange it for you.
     
  3. Old Dubber

    Old Dubber Active Member

    Messages:
    275
    Location:
    Everton Hills, Brisbane
    My '68 goes 48cm, but this could vary with the condition of the bump stop.
     

Share This Page