1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

New sliding door seal

Discussion in 'Bay Tech Clinic' started by Happy_Camper, Jul 12, 2016.

  1. Happy_Camper

    Happy_Camper Active Member

    Messages:
    344
    Location:
    Coffs Harbour
    hey guys I've installed my new sliding door seal but something isn't quite right, the door isn't even closing as it's hitting on this point.
    Is it upside down? Back to front? I dunno haha
    image.jpeg image.jpeg
     
  2. ruby6689

    ruby6689 Well-Known Member

    Messages:
    8,433
    Location:
    Burnett Heads
    I think you just need to squash it in a bit more at the top and bottom. Maybe seat the corner first then ease it back across the top and along the side.
     
  3. lachie

    lachie Member

    Messages:
    164
    Location:
    terranora
    yep- squash your corner in first - sometimes stretching rubber to get it thin enough to fit the channel may be necessary (and cutting and joining if excess material).
     
    ruby6689 likes this.
  4. Happy_Camper

    Happy_Camper Active Member

    Messages:
    344
    Location:
    Coffs Harbour
    Cheers guys. A bit more manipulation and now it seated in nice. Door still takes a bit to close as it's hitting the rubber. But after a while I'm sure it will wear in.
    Cheers Matt
     
    ruby6689 likes this.

Share This Page