Roy - Seat Belt Question for you.

Discussion in 'The Bus Stop' started by 68BUS, Sep 19, 2012.

  1. 68BUS

    68BUS Well-Known Member

    Messages:
    4,216
    Location:
    Brisbane
    Roy,

    Can you please advise the best configeration for installing seatbelts into a split for the middle rear full width seat.
    I assume that the inertia reel lap and sah belts with the webbed buckle strap is the way to go.
    As well as the static lap belt with the Webbed buckle as it is a bench seat.

    Do I need the floor brackets as well? Or are these for the buckle style that has the hard cable?
    http://www.thebusstop.com.au/busstore/products/82/175/inertia_seatbelt_brackets_-_pair/

    And I also assume that all your belts fit the captive nut plates you sell that can be used under the floor?
     
  2. Roy

    Roy Administrator Staff Member

    Messages:
    5,562
    Location:
    Mudgeeraba, Qld
    Hi
    It would be best if you asked an engineer what his requirements would be to certify any changes.
    Extra anchor points would be needed if you install inertia or static lap & sash belts
    Brackets would be needed if you go with Inertia
    Cheers
    Roy
     
  3. 68BUS

    68BUS Well-Known Member

    Messages:
    4,216
    Location:
    Brisbane
    Cheers mate.
    Spoke with anita and she sent me one of the inertia belts.
    Started fitting the points under the bus and threw my back out.
    At least I have a good book. Didn't want to take the boys surfing this weekend anyway!!!
     
  4. gazman

    gazman Well-Known Member

    Messages:
    1,767
    Location:
    Perth WA
    Gettin old huh Brad? :p
     
  5. 68BUS

    68BUS Well-Known Member

    Messages:
    4,216
    Location:
    Brisbane
    Nope.
    Just weaker!
     

Share This Page