1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Screw thread size and length inner sliding door handle T2 bay

Discussion in 'Resto Corner' started by Daz77, Nov 6, 2016.

  1. Daz77

    Daz77 New Member

    Messages:
    16
    Location:
    Sydney
    Hi all, I have lost the screw that holds my inner sliding door handle on my bay to the lock mechanism, the handle is the same as the cream coloured one shown in the picture below. Does anyone know the type of screw?
    Thank you.






    Screen Shot 2016-11-06 at 21.51.16.png
     
  2. kool_kombi 79

    kool_kombi 79 Well-Known Member

    Messages:
    380
    Location:
    Brisbane
    M5 x 20 long should do the trick on that one.
    They do have a habit of coming out so a little loctite thread lock will help keep it in place, only a little bit, one drop would be heaps.
     
  3. Grantus

    Grantus Well-Known Member

    Messages:
    17,521
    Location:
    Southern ACT
    Whatever happened to starting a post in the "New Members" forum, for a quick introduction, so members can welcome you aboard, before just leaping in wanting help straight up? o_O

    Or have I just been a member too long, expecting a little etiquette ???? :p
     
    Syncro27 and oldman like this.
  4. Daz77

    Daz77 New Member

    Messages:
    16
    Location:
    Sydney
    Thank you so much kool_kombi.

    Point taken Grantus
     
    Grantus likes this.
  5. kool_kombi 79

    kool_kombi 79 Well-Known Member

    Messages:
    380
    Location:
    Brisbane
    No worries Daz77.

    Welcome to the club.

    There you go your in. :)
     
    Mordred likes this.

Share This Page