1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Throttle hinge pin position?

Discussion in 'Splitty Tech Clinic' started by KOMBI NIKO, Nov 5, 2013.

  1. KOMBI NIKO

    KOMBI NIKO Member

    Messages:
    203
    Location:
    frankston south
    Hi guys was wondering if anyone can check the position of the hinge pin location so I can weld the new on into my new floor section?
    i also need the location of the hole right in front of the hinge as the auto craft floor repair piece has zero.

    cheers,
    Niko.
     

    Attached Files:

  2. Old Dubber

    Old Dubber Active Member

    Messages:
    275
    Location:
    Everton Hills, Brisbane
  3. KOMBI NIKO

    KOMBI NIKO Member

    Messages:
    203
    Location:
    frankston south
    That's not my pic just one off the net, I really need measurements. Here's a pic of mine maybe I could get 3 measurements like shown here??
     

    Attached Files:

  4. splitbus

    splitbus Well-Known Member

    Messages:
    3,362
    Location:
    Brisbane
    Horizontal line measurement .......... 188mm

    Vertical line measurement............... 200mm and to top of hole 115mm in direct line with pressing

    Line dropping to left measurement... 225mm
     
  5. KOMBI NIKO

    KOMBI NIKO Member

    Messages:
    203
    Location:
    frankston south
    Cheers thats going to help ;)
     
  6. KOMBI NIKO

    KOMBI NIKO Member

    Messages:
    203
    Location:
    frankston south
    How big is the hole above the hinge?
     
  7. splitbus

    splitbus Well-Known Member

    Messages:
    3,362
    Location:
    Brisbane
    30mm........
     
  8. KOMBI NIKO

    KOMBI NIKO Member

    Messages:
    203
    Location:
    frankston south
    cheers Mike :)
     

Share This Page