Wheels

Discussion in 'Bay Tech Clinic' started by Brencallaghan, Nov 1, 2017.

  1. Brencallaghan

    Brencallaghan New Member

    Messages:
    6
    Location:
    Pelverata
    Does anyone know if T3 wheels will fit straight onto a T2.

    Bren
     
  2. rstucke

    rstucke Active Member

    Messages:
    273
    Location:
    Wamberal NSW AUS
    yep
    careful if your sourcing wide wheels, there's not as much room in a t2
     
  3. tillis

    tillis Active Member

    Messages:
    109
    Location:
    gold coast
    fat 013.jpg

    no not much room at all...i could only fit 255/65/16 on 7.5 merc rims...its the offset(et) that counts
     
  4. Grantus

    Grantus Well-Known Member

    Messages:
    13,189
    Location:
    Southern ACT
    Yes, stock factory T3 wheels are a straight bolt on fit. :)

    It’s when you get to other alloys, that came off a T3, that you may need to check carefully for offset and clearance, as mentioned above.....;)
     
  5. Brencallaghan

    Brencallaghan New Member

    Messages:
    6
    Location:
    Pelverata
    Thanks very much,

    bren
     

Share This Page