Thanks Wayne :)
Thanks Wayne. Is that 8mm ID or OD? I have the opportunity to modify my tank so was considering this as an option. I'm still running a mechanical...
OK, here goes with the dumb question. My Bay has a fixed ie welded fuel tank outlet spigot. I noticed in some pics that the tanks had a tapped insert...
Dapom, the gas strut idea is worth checking into. Thanks. Adrian, I visited Speco. All modern carburettor setups use a different kind of system;...
Thanks Grumble. The issue is that the balls are steel and part of the Carby bodies and would require modification to use the HEIM style joints that...
Thanks for the tip. Someone else mentioned it and it seems less drastic than drilling off the balls on all the carbies. Probably needs very little in...
These are the ball sockets that have worn on my carbie linkages. I can't find any replacements listed anywhere. Some have suggested replacing them...
OK, it's going, going, gorn !
Sorry Alpal, here you go with the pics. The first is showing a foam seal I made but not sure if it will survive, the second shows the opening to the...
Welcome back Andrew. Nearly finished that type iv motor you've been helping out with. Nearly there :). Darren
I'm getting to the last part of my type 4 rebuild and it's the little bits that are driving me crazy (or crazier as those who know me will attest...
Just fitting up my throttle linkage crossbar and was wondering how much play is normal on the RH (Driver) side? The LH is quite play free but the RH...
Separate names with a comma.