I put longer studs from brikwerks on the microbus, bit of messing about pressing in and out the studs, but like you say, helps me sleep better while...
I’ve got a couple of weird looking 13mm Webber manifold specials. Super cheap spanners heated up and bent with the oxy!
Sounds like connected wires wrong by PO.
I bought a spare sc lock a couple years back from mikki piro(sp?) cost a bit....... But when you need one what do you do?
As close to taswegia as we’ll get!
I was going to look into using Milwaukee’s one key system for low cost.
A large immovable object such as a tree and come along with all wheels chocked and or the tail end chained down would be kinder than all the force...
Fuel will go stale too, leave as little as possible, but then theres the condensation forming risk......
Weldie!!!
You’ll need a heck of a hole.....
If you had 10V as in original post( not ams as described) on your volt meter, your ignition system will struggle to make good spark at higher rpm for...
Just as Bay's are the choice if you haven't got the $$ to have a Split, T3's have become go to if you haven't the $$ to have a Bay, or if you think...
I did just this with a beetle passenger side quarter panel repair recently, pushed a flat section of sheet against the repair area to get the basic...
Ahh the good old percussion micrometer.
Separate names with a comma.
