Make sure the two contact faces are square with each other. A lot are not out of the box and will give you a skewed result. just requires a small...
Probably to stop you over torquing a metal plug in an aluminium case?
chisel and hammer works well
i wouldn't go near any oil filled coil especially the GT40.
you will be able to fit anything up to early 1974. 1975 on wont even come close. All the aftermarket ones look the same and look like they come from...
Here’s a drone shot of most of the 307 Kombi’s from Sunday
The line up for the convoy
make sure the muffler is adequately supported so the whole exhaust system is not hanging of the exhaust bolts. Stainless will crack.
Are you more worried about her or the T3? :P :P
I can only speak for the WOSP ones that I sell because that is what I have experience with.
- They have more power than standard manual starters...
not as far as im aware. the auto starter is the same offset as the 1600.
No that gear is too short, it will suit 1600, 1800 and all auto bell housings.
It is what is colloquially know as a "hi-torque" starter and the...
Probably m8x1.25 like pretty much everything else on the Kombi! The only m8x1 spot I know is the odd sized hole on top of the type 4 engine.
Nothing conclusive, just throwing ideas out and considering syncro's post above.
If the oil pump is too big (possible with it being modified type 1...
m8 x 15mm
I thought general consensus was 40psi cold idle then 10psi warm idle and 10psi per 1000rpm
Do you think it could have something to do with the oil pump? Looks like a modified type 1 pump.
Or the 160kw electrical boost. Enough to push a family saloon down the highway nicely
First thing I would do is bleed the entire brake system. Brake fluid is hygroscopic and absorbs water. After 20 years without use you might find that...
I'm pretty sure its right here...
Separate names with a comma.