The lights in the instrument cluster have been flickering since I put it back in, sometimes they work....sometimes they don’t. The odometer numbers...
That’s it Marty Subaru code K3X
Another small task out of the way. My donor van was smashed in at the front so I could not recover the two pieces of “J-channel” that are used to...
It was raining...I was bored....one thing led to another and before I knew it I had installed the tent on the pop top roof...with the flat bar. I...
You guys are right, I guess I am just too keen to get this done and finally get the top on, and it would be a shame if it didn’t work. I will try to...
Pressing on with flat aluminum strip ... hope it holds:cool: [ATTACH]
New problem for the day, I had planned upon installing the pop top tent onto the roof today. Unfortunately I did not get the original aluminium...
I pushed through the heat over the weekend and installed some gutter mounts on the Pop Top. I chose these ones from Rhino Rack, they seemed pretty...
Had me worried, I had to go down to the shed and check.
I was checking the left and right seals for my sliding windows today and realized that they are both the same size in spite of different stock...
Hi John, your Dora windows look very similar to mine so just follow my directions for disassembly/assembly and you should be fine, if you get into...
I finished the second slider frame this morning, only took about an hour this time. It is so much simpler to install both panes together and then...
thanks Jethro. I forgot to explain that the slider panel went in pretty easy, you just lay the bottom aluminum strip in the channel and then gently...
In a round about sort of way Col, but hey life would be pretty boring without some challenges.
OK one slider down, hopefully with the knowledge gained through this the next one will go together a little easier. [ATTACH] For anyone choosing...
Next I installed some new felt into the slider lock bar and in the vertical end bar that attaches to the fixed pane. I then applied a small bead of...
Next on my rainy day list was to re-assemble my sliding windows. I pulled these apart to get sprayed black and have the glass tinted. First thing...
I then wound the window back down again and carefully installed the scrapers. Once the scrapers were installed I would the window back up again and...
After the lift bracket was correctly installed on the window I used some ducting tape to tape over the scraper clips so that the window could be...
Finally got around to re-installing my driver window today. On my first attempt I managed to scrape a bit of the tint off on one of the inner...
Separate names with a comma.
