1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

mags hitting sway bar.

Discussion in 'Bay Tech Clinic' started by Justin_101, Apr 14, 2013.

  1. Justin_101

    Justin_101 Member

    Messages:
    126
    Location:
    Willunga, Adelaide
    hey all,

    i have just installed longer studs for every wheel, so i can put my 18x8.5 mags. they all fit very good. but just on full lock the front ones hit the sway bar as you can see in the pic. does anyone know if i can get a after market sway bar which goes on more of an angle away from the wheel. im surprised thats all it hits on. clears everything else fine!
    cheers Justin

    [​IMG]
     
  2. Justin_101

    Justin_101 Member

    Messages:
    126
    Location:
    Willunga, Adelaide
    or am i better off gettin a 15mm spacer?
     
  3. Alpal

    Alpal Moderator Staff Member

    Messages:
    8,915
    Location:
    Melbourne Bend of Islands
    Think there is an adjustable stop to the travel. Will reduce the turning circle but not significantly.
     
  4. oldman

    oldman Super Moderator Staff Member

    Messages:
    9,841
    Location:
    Avalon Beach NSW
    As Al said. Located below the centre of the front beam...two bolts - one for each side....inwards will decrease the turn radius, outwards will increase the turn radius. Cheers, mark
     

Share This Page