1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Popping and backfires

Discussion in 'Bay Tech Clinic' started by Ian and Shelley, Apr 7, 2019.

Page 2 of 2
  1. Ian and Shelley

    Ian and Shelley Active Member

    Messages:
    225
    Location:
    Umina Beach
    Ohh yes... got it this time

    Thanks
     
    Ian and Shelley, Apr 10, 2019
    #21
  2. Ian and Shelley

    Ian and Shelley Active Member

    Messages:
    225
    Location:
    Umina Beach
    Fantastic advice. Thanks again..


    Took the carby off and gave a good clean, blow through jets,, replaced a few old rubber seals, and its running bloody lovely...

    Better acceleration smoother idle and no more popping when coasting..

    Thank you!
    [
     
    Ian and Shelley, Apr 11, 2019
    #22
    David H, Wayne murray, tintop and 3 others like this.
  3. Ian and Shelley

    Ian and Shelley Active Member

    Messages:
    225
    Location:
    Umina Beach
    Any plans for a catch up in or around Sydney or the Central Coast any time soon?
     
    Ian and Shelley, Apr 12, 2019
    #23
  4. Ian and Shelley

    Ian and Shelley Active Member

    Messages:
    225
    Location:
    Umina Beach
    I should probably go and have a look on the Kombi events forum page !!
     
    Ian and Shelley, Apr 12, 2019
    #24
  5. melissa

    melissa Administrator Staff Member

    Messages:
    14,949
    Location:
    Newcastle NSW
    We have Bus Stop to get out of the way first - then Bugs and Buses By the Bay : https://www.facebook.com/events/233516730910137/
     
    melissa, Apr 12, 2019
    #25
  6. Wayne murray

    Wayne murray Well-Known Member

    Messages:
    3,141
    Location:
    Seven hills
    Nationals in the middle, in end of May
     
    Wayne murray, Apr 12, 2019
    #26
  7. Grantus

    Grantus Well-Known Member

    Messages:
    16,118
    Location:
    Southern ACT
    Yup! ;)
     
    Grantus, Apr 12, 2019
    #27
  8. David H

    David H Well-Known Member

    Messages:
    5,207
    Location:
    newcastle
    Which conflicts with Berry Blast From The Past:(. I'm staying home & keeping warm:) so it's Bugs & Buses for us:D.
    Cheers
     
    David H, Apr 12, 2019
    #28
  9. grumble

    grumble Well-Known Member

    Messages:
    1,060
    Location:
    Taree
    Have you got the cables connected to the right terminals? red to the negative of the coil and black to ground and the main dial on dwell.
     
    grumble, Apr 12, 2019
    #29
    Grantus likes this.
  10. Grantus

    Grantus Well-Known Member

    Messages:
    16,118
    Location:
    Southern ACT
    Wussss.... :p
     
    Grantus, Apr 12, 2019
    #30
    Wayne murray likes this.
  11. grumble

    grumble Well-Known Member

    Messages:
    1,060
    Location:
    Taree
    47-53 degrees and reset timing, then adjust the mixture screws and balance the carbs at idle and 1500 rPM.
     
    grumble, Apr 12, 2019
    #31
  12. Ian and Shelley

    Ian and Shelley Active Member

    Messages:
    225
    Location:
    Umina Beach

    All connected correctly just a cheap inaccurate meter...
     
    Ian and Shelley, Apr 12, 2019
    #32
Page 2 of 2

Share This Page