1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Techo goodies

Discussion in 'Engine & Transmission' started by kombiwhisperer, Apr 11, 2016.

  1. kombiwhisperer

    kombiwhisperer Member

    Messages:
    146
    Location:
    fraser coast queensland
    Trialing a new cooling system
    Pumps oil out of one side of sump through filter and electric turbo scavenge pump, into coooler and back into other side of sump(baffled inside)
    The pump delivers 3lt/mins, I am thinking that the slower pass through cooler should cool more effectively
     

    Attached Files:

    Aspro likes this.
  2. Alpal

    Alpal Moderator Staff Member

    Messages:
    8,995
    Location:
    Melbourne Bend of Islands
    Hanging low? Also how would it go off bitumen?
     
  3. kombiwhisperer

    kombiwhisperer Member

    Messages:
    146
    Location:
    fraser coast queensland
    Not lowest point, rails lower, plan to put a mesh belly tray in once finished testing, never had a cooler damaged but I have been known to go to crazy camping spots
    Temp differential from ground doesn't seem drastic
     
  4. peter drogi

    peter drogi Member

    Messages:
    68
    Location:
    bass hill
    I have had similar ideas, my return was going to be via the rocker cover into the number 3 cylinder area.
    The cooler oil bathing the hottest part....
     
  5. kombiwhisperer

    kombiwhisperer Member

    Messages:
    146
    Location:
    fraser coast queensland
    Good thinking '99
    May have a bit top much oil flowing up there but, will do the numbers
    Found good spot for oil pressure guages on Type 4 engines too
     

    Attached Files:

  6. Alpal

    Alpal Moderator Staff Member

    Messages:
    8,995
    Location:
    Melbourne Bend of Islands
    That's neat. Never liked the wires hanging under.
     

Share This Page