1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

The Identify-That-Part Game

Discussion in 'Bay Tech Clinic' started by DrowningBitByBit, Mar 14, 2020.

  1. DrowningBitByBit

    DrowningBitByBit Active Member

    Messages:
    79
    Location:
    Tugun, Gold Coast
    I was fiddling about in the front of the van beneath the mats and found these two little doobries sitting next to the gear shifter plate. They were under the mats so haven't just fallen there recently. Should have added something for scale - they're each about an inch long.
    Over to you...

    [​IMG]
     
  2. gazman

    gazman Well-Known Member

    Messages:
    1,846
    Location:
    Perth WA
    pop rivet stems...
     
    DrowningBitByBit likes this.
  3. Barry

    Barry Well-Known Member

    Messages:
    4,773
    Location:
    Abbotsford NSW
    As Guzman said.

    The bit to the left in the pic that is cut off after it has pulled the “ball” through

    8DB96090-D544-451D-B62B-F7803DDB3CE0.jpeg
     
    DrowningBitByBit likes this.
  4. DrowningBitByBit

    DrowningBitByBit Active Member

    Messages:
    79
    Location:
    Tugun, Gold Coast
    Okay, thanks, that's good, so I shall do the sensible thing and ignore it.
     
    Barry likes this.
  5. Wayne murray

    Wayne murray Well-Known Member

    Messages:
    3,728
    Location:
    Seven hills
    You can try to install them,but were into, that's another thread;):rolleyes:o_O
     
    DrowningBitByBit likes this.
  6. Wattie

    Wattie Well-Known Member

    Messages:
    1,118
    Location:
    Mildura. Victoria. Australia.
    aaah, the old pop rivet stems, should be renamed tyre magnets. :eek:
     
    Syncro27 and DrowningBitByBit like this.
  7. Barry

    Barry Well-Known Member

    Messages:
    4,773
    Location:
    Abbotsford NSW
    That is already taken by Tek screws
     
    Wattie and tintop like this.

Share This Page